Tabla de contenido
Publicidad
10 | English
English
Quick-clamping nut with bar
Please observe the original operating instruc-
u
tions for the power tool used.
The quick-clamping nut with bar (1) must be
u
used for the AdvancedGrind 18, GWS 18V-10 C,
GWS 18V-10 SC angle grinders for all grinding
and cutting discs. This quick-clamping nut may
only be used up to a maximum diameter of
150 mm.
Use only a flawless, undamaged quick-clamping
u
nut.
When screwing on, make sure that the printed
u
side of the quick-clamping nut is not facing the
grinding disc.
1 609 92A 4KR | (17.07.2018)
Bosch Power Tools
Publicidad
Tabla de contenido
