Replacing The Fuse On The Visulas Yag Iii Control Unit - Zeizz VISULAS YAG III Instrucciones Para El Uso

Maintenance / Miscellaneous
Replacing the fuse on the VISULAS YAG III control
unit
The control unit fuses are integrated into the combined power inlet
connector/fuse assembly. This assembly is located on the rear side of
the control unit ( 7, Fig. 9).
• Turn the instrument off at the power switch.
• Disconnect the power cable.
• Open flap (1, Fig. 37) using a suitable tool.
• Remove the defective fuses and insert new ones.
Note
Use fuses with the correct rating only.
( Technical Specifications, page 70)
000000-1354-664 VISULAS YAG III 15.08.2005
1 Flap
Fig. 37 Replacing the fuse
61