Brizo MultiChoice T600 Serie Manual Del Usuario página 4

60 Series Installation
2 Valve Trim Installation
(See page 5 & 6 for Siderna
A.
1
Slide O-ring (1) over cartridge and the bonnet
nut (2). The O-ring, which acts as a spacer to
steady the sleeve, should rest behind the
bonnet nut.
Note: Depending on the location of the valve
within the wall and wall thickness, an optional
extension kit (RP74785) can provide an ad-
ditional 1 3/4" of wall thickness.
C.
1
3
Secure the escutcheon (1) to the bracket (2) with
the 2 screws provided (3). Do not overtighten
escutcheon screws.
102223 Rev. B
valve trim installation.)
®
2
2
B.
2
If your model requires a spacer (1), install it into
sleeve (2). Slide the sleeve over the cartridge, body
and O-ring. Ensure sleeve is properly positioned
over the front of cartridge.
D.
3
2
1
4
5
Slide trim ring (1) over the cartridge and sleeve
and into the escutcheon. Install volume control
handle base (2) with lever to the right as shown
(3). Install set screw (4) or (5) followed by the
handle lever (6) or (7).
On most models, lever should point
E.
downward to 6 o'clock position. Install set
screw (8) into handle (9). Push handle
onto valve cartridge and tighten set screw
to secure handle.
Note: Some models include set screw
covers for volume control handle that
should also be installed.
4
1
E.
9
6
8
7