Cequent Performance Products 41948 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 41948F
Wrenches: ¾", 21mm
Drill Bits: None


Cross Member
Bracket
(Bumper Bracket)
Member
Note: All Fasteners Typical Both Sides of Vehicle

CARRIAGE BOLT- ½" – 13 X 1 ¾" GR5
Qty. (4)

CONICAL TOOTHED WASHER – ½"
Qty. (4)

BLOCK – 1/4" X 1" X 3"
Qty. (4)
Removal of the spare tire will make installation easier.
1) Remove the existing M14 bolts from each cross member bracket.
2) Feed pull wire through vehicle cross member (figure 3). Attach block (Item 3), and carriage bolt (Item 1), and pull fasteners
through vehicle cross member and into position as shown (figure 2).
3) Fishwire blocks and carriage bolts through the frame rails into the existing holes in the vehicle.
4) Raise hitch into position,
5) Install 1/2 flat washer (item 5) between frame rail and hitch as shown for rear attachment.
6) Reinstall existing M14 bolts through receiver and frame into existing weldnuts.
7) Loosely install conical washers (Item 2) and nuts (Item 4) onto carriage bolts.
8) Torque all fasteners to specifications.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust
fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or
attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2013 Cequent Performance Products, Inc - Printed in Mexico
Installation Instructions
Bumper
Frame Rail
Access Hole

Cross
FIGURE 1
Tighten all M14 X 1.5 (fine thread) fasteners with torque wrench to 148 Lb.-Ft. (201 N*M)
Tighten all ½"-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
RAM 1500
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
Route for Long Bed (8')

Existing
Weldnuts

Existing
M14 Bolts

Qty. (4)

Qty. (2)

Qty. (4)
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
15,000 (6810 kg)
12,000 (5448 kg)
Accessory Rating
Kink pull wire to keep
blocks independent of
bolt.



Member

HEX NUT- ½"-13
FLAT WASHER- ½"
PULL WIRE- 1/2"
41948N 12-10-13
Form: F205 Rev B 11-11-2010
41948
Max Tongue
WT (LB)
1,500 (681 kg)
1,500 (681 kg)
D
FIGURE 2

Cross
FIGURE 3
Rev. A