EAS ELECTRIC EMCH Serie Manual De Instalación Y Manual De Usuario página 157

c. Setting function parameters
Press "FUNCTIONS" key to choose operation parameters. The setting function parameters will change as
the following order each time the key is pressed:
→
1) Timing setting: 3 timing periods can be set on the wired controller: Timer 1, Timer 2, Timer 3. These 3
timers can control the main unit to be turned ON and OFF 3 times at most during a day.
2) Setting method: press "FUNCTIONS" key under main page twice to enter timing setting. Then the LCD
will display as the following:
At this time the hour of the clock will flash, which means the current setting is the hour of Timer 1 "On",
press the "▲" or "▼" to adjust, press " " key when finished, and then the minute of the clock will
flash, which means the current setting is the minute of Timer 1 "On" , press the "▲" or " ▼ " to adjust,
press " " key when finished, the LCD will display as the following:
At this time the hour of the clock will flash, which means the current setting is the hour of Timer 1 "Off",
press the "▲" or "▼" to adjust, press "
flash, which means the current setting is the minute of Timing 1 "Off" , press the "▲" or "▼" to adjust,
press " " key when finished, the LCD will display as the following:
At this time the hour of the clock will flash, it means the current setting is the hour of the Timer 2 "On".
And the follow setting method will be the same as the Timer 1. Similarly, the setting of Timing 3 is the
same as this method. After setting is finished, press "OK" key or wait for 7 seconds to confirm the setting,
62
→
→ →
TIMER
1
ON
TIMER
1
OFF
" key when finished, and then the minute of the clock will
TIMER
ON
V.2