Position Six Self-Adhesive
Pads to the Top of the Pedestal.
2. Install the Lavatory
Apply six self-adhesive pads along the top surface of the
pedestal.
Mark the pedestal centerline on the floor.
CAUTION: Risk of personal injury or product damage. This
pedestal lavatory is heavy. Get help lifting and moving it.
Position the pedestal on the floor centerline. Refer to the
roughing-in information for correct placement.
Carefully lift the lavatory into place on the pedestal. Level the
lavatory and add additional self-adhesive pads as needed to level.
If the bottom of the lavatory contacts the pedestal, reposition the
self-adhesive pads as needed. Make sure the lavatory fits flat
against the finished wall.
Refer to the roughing-in information to ensure the correct
distance between the pedestal and the wall.
Mark the two lavatory anchoring holes on the finished wall.
Mark the pedestal anchoring hole on the floor through the hole in
the pedestal bottom.
Carefully remove the lavatory from the pedestal.
Carefully move the pedestal and lavatory away from the
installation area.
Drill 3/16" holes at the marked locations on the finished wall and
floor.
Sterling
Hanger Bolt
Pedestal
Lag Bolt
Washer
5
The drain and
faucet are not
shown to
improve clarity.
Cap Nuts
Washer
The pedestal
height is reduced
to improve clarity.
1019859-2-B