Vollrath Wedgemaster II Manual Del Operador

Thank you for purchasing this Vollrath equipment. Before operating the
equipment, read and familiarize yourself with the following operating
and safety instructions. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. Save the original box and packaging. Use this packaging
to ship the equipment if repairs are needed.
SAFETY PRECAUTIONS
To ensure safe operation, read the following statements and understand
their meaning. This manual contains safety precautions which are
explained below. Please read carefully.
WARNING
Warning is used to indicate the presence of a hazard that will or can
cause severe personal injury or death.
CAUTION
Caution is used to indicate the presence of a hazard that will or can
cause minor or major personal injury if the caution is ignored.
NOTICE: Notice is used to note information that is important but not
hazard-related.
To reduce risk of injury or damage to the equipment:
• Check unit before each use to ensure the equipment is clean.
• Check for broken, nicked or dull blades and if found, replace the
blade assembly.
• Check to ensure that the pusher head sits down completely on the
rubber bumpers.
• If necessary, lubricate guide rods using a light coating of mineral oil,
Petrol Gel, or food grade lubricant. DO NOT USE COOKING OIL AS IT
WILL BECOME STICKY AND MAY PERMANENTLY DAMAGE THE
PUSHER HEAD BEARINGS.
FUNCTION AND PURPOSE
Intended for wedging vegetables and fruits.
Please register your product at Vollrath.com/ProductRegister
©
2017 The Vollrath Company L.L.C.
Operator's Manual
Wedgemaster
Item No. Description
700-1 6 section cut Wedgemaster™ II
700-4 8 section cut Wedgemaster™ II
FEATURES AND CONTROLS
A
D
C
F
G
A Guide Rods. Guide and align the pusher head onto the blade
assembly.
B Handle. Used to lower and raise the pusher head.
C Bumpers. Cushions the stop of the pusher head.
D Pusher Head Assembly. Made up of the handle and the pusher
head block.
E Blade Assembly. Houses the blades. Specifically sized to match
the corresponding pusher head block.
F Base Assembly. Holds the guide rods and the blade assembly.
G Legs. Supports the unit and holds the blade assembly.
®
II
A
B
E
C
Part No. 2350025-1 ml 1/24/17