Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SAFETY RULES
Thanks for choosing our McCulloch garden tool, we are convince that you will be satisfied with this low cost, no noise and
no lawn mower pollution's please read all instructions in this manual carefully before using mower.
•
Inspect your lawn for any debris or foreign
objects and remove them before mowing.
•
Never place your hands, fingers or feet inside the
reel.
Although not powered by a motor, when the
wheels turn, the reel cuts.
•
Never mow when the grass is wet enough to be
slippery.
•
Don't place your hands or feet near a moving
part of the mower.
•
Don't operate the mower while barefoot or
wearing sandals.
•
Walk slowly, never run. Always be sure of your
footing when operating the mower.
•
Never intentionally strike or ram trees, fences,
etc. This can cause injuries or severely damage
the mower.
•
Remember that this mower is a precision piece of
lawn care equipment. Treat it as such by exercis-
ing caution when using it.
•
Make sure your mower is in safe operating condi-
tion. Don't attempt to operate the mower if it is
damaged. have it repaired first.
OPERATION
•
HANDLE
1.
Enclosed in carton are the : mower handle parts
(1 foam grip, 1 top handle piece, 2 center handle
pieces and 2 lower handle pieces ) and hardware
package.
2.
Insert the top handle piece into the from grip,
(for easier application, you can lubricate the
inside of the from handle grip with dishwashing
or liquid hand soap).
3.
Insert the 2 center handle piece into the left and
right side of the top handle piece.
4.
Connect the right lower section with the left
lower section and secure with two of the 1-3/8"
long bolts and Nyloc nuts provided.
5.
Fasten the upper handle subassembly that your
assembled in the preceding step to the lower
handle subassembly using the four remaining 1-
3/8" long bolts and Nyloc nuts provided.
6.
Be sure to tighten all hex nuts on the joints of
the handle assembly of that none of the handle
pieces are loose.
Top Handle Section
Soft Grip
Center Handle
Hex Nut
Rear of
Mower
ATTACHING THE HANDLE TO THE
MOWER (FIG. 2)
•
As you follow the instructions below, refer to fig.
2 for more information.
•
After assembling the handle, fit the holes at the
end of the lower portion of the handle on the
left and right side, over the short posts extending
out from the side plates.
•
When the handle is in place over the posts, snap
the "C clips" onto the slotted posts on both sides
to prevent the handle from coming off.
"C" clip
Slotted Post
Fig. 2
1
Section
Hand
Bolt
Hex Nut
Hand Bolt
Lower Handle
Front Mower
Front of
Mower
Publicidad
Tabla de contenido
