Nice RMF3004 Manual Del Usuario página 80

Automatic sending of digital, from
the MG 3000 Module to biometric
scanners on RS-485 channels.
Occurs after Receiver Update or
Individual User Update.
Line 1: ID: xxxx yyyy, where xxxx
corresponds to the user ID and
yyyy to the Channels (1 to 4) that
confirmed the received data.
Line 2: Sending progress, where
USER corresponds to user data,
FP1 to Digital 1 and FP2 to Digital 2
(if available).
(REC CTWB and REC TX+CTWB
modes only)
Configuration of UHF Antennas
connected to RS-485 channels
in progress. Occurs always after
physical connection of the Antenna
or when the Receiver is restarted.
(PASSIVE TAG and REC TX+TP
mode only).
Indication of UHF Antennas connec-
ted to RS-485 channels configured
correctly (OK) or not present (Err).
Fault indication in the Receiver's
CAN circuit. Send the equipment to
Maintenance.
- ENGLISH -
24
80