SPORTSTECH SX200 Manual De Usuario página 33

Slide the seat post (12) into the vertical Seat post (10) , at the desired position, align holes and fix in
place with the Locking Knob (25) and flat washer (26). Now fix the Seat (13) to the seat post (12)
as shown. Insert the vertical Seat Post (10) into the main frame (16) and line up the holes. Secure
the saddle in position with the Adjustment Knob (7). The correct height for the seat can be adjusted
after the bike is fully assembled.
Slide the Handlebar Post (pt.17) into the handlebar post housing on the main frame. You will have to
slacken the knurled section of the Spring Adjustment Knob (pt.7) and pull the knob back and then
select and align holes for the desired height. Release the knob and retighten the knurled portion.
Remove the bolts and spring washer from the Hand- lebar Post (pt.17), then fix the Handlebar
(pt.18) with 4pcs Ø8 the Spring Washer (pt.19) and M8*15 the Bolt (pt.20).
ATTENTION: YOU SHOULD FIX THE HANDLEBAR TIGHTLY
Slide the Computer (pt.23) onto the Computer Holder (pt.22) with bolt(pt.81) connect the plug
(A1&A2),
33