Single-Phase Loads - MarelliMotori MXB-E 225 Serie Manual Del Usuario

U1
STANDARD
T1
USA MARKET
WARNING! The internal connection diagrams of the generators are reported in the manual of the voltage
regulator.
Fix the output cables to the terminals of the generator, as shown in Figure 6:
Rotation direction
The generators are usually provided to work with a clockwise rotation (from the coupling side).
Ground connection
The terminal box contains a terminal for ground connection while a second terminal is located at the foot of the
generator. Connect the ground connection with an appropriate copper conductor, in line with the regulations in
force.

5.7 Single-phase loads

The three-phase generators of this series can be used as single-phase generators when following the
indications reported here below:
The generator can be used at a maximum power of 0.6 times the rate reported on the plate for the three-
phase load.
The generator can be connected to the parallel star (220 Volts at 5Hz required or 220-24V at 6Hz) and the
single phase must be connected to terminals U1/T1 and V1/T2.
W5
T9
The generator can also be connected in a zig zag (220-240 Volts at 5Hz required or 220-24V at 6Hz) and the
single-phase load must be connected to terminals U1/T1 and V1/T2.
963857253_=
CABLE MARKERS
V1 W1 U2 V2
T2 T3 T4 T5
LINE
YES
Collegamento stella parallelo
Parallel star connection
U1 U5
T1 T7
LOAD
CARICO
T4 U2 U6 T10
W6 V2
T12 T12
V1
W2 V6
T2
T6 T11
W1 T3 V5 T8
W2 U5 V5
T6 T7 T8
WINDING
U6
(T10)
U2 (T4)
W5 (T9) V5
(T11)
(T5)
V6
(T3)
W1 V1
V2
W6 (T12)
W2 (T6)
110 V
W5 U6 V6
T9 T10 T11
LINE
NO
Fig. 6
BIANCO-WHITE
NERO-BLACK
ROSSO-RED
(T8) U5 (T7)
(T2) U1 (T1)
220 V
Fig.7
W6
T12
35