Dash Disassembly - Metra 95-8721B Instrucciones De Instalación

1. Unclip and remove cover around
shift lever and cup holder.
(Figure A)
2. Unclip and remove ashtray
assembly. (Figure B)
3. Remove (2) Torx screws from the
bottom of the climate control unit
then remove the unit. (Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
95-8721B
4. C-Class only: Inside each vent,
using a small flat screwdriver
push the lower tab inward toward
the center of the vent and then
rotate each vent up to expose (1)
Torx head screw. Loosen the Torx
(Figure D)
2
screws (It is not necessary to remove
the screws.) Push the upper clip
inward and rotate the vent downward
to expose (1) spring clip in the top of
the vent assembly. (Figure D)
Continued on next page