General Instructions For Care And Maintenance; Replacing The Light Bulb - Jocel JF-300L Manual De Funcionamento

GENERAL INSTRUCTIONS FOR CARE AND MAINTENANCE

The refrigerator should be cleaned every other month, before cleaning; the electric plug must
be removed from the power supply.
Wipe the inside and outside of the refrigerator with a wet soft cloth.
If it's too dirty, clean with a soft cloth soaked with neutral detergent and clean water, remove
the moisture with dry cloth.
If you are going away on holiday or for any other reason, wish to leave the refrigerator idle for
any period of time, proceed as follows:
− Disconnect the refrigerator from the electric power supply by removing the plug from the
wall socket.
− Remove all food.
− Clean and dry the inside as instructed in the direction given above for cleaning.
− Leave the doors open to prevent any unpleasant smells from building up while the
refrigerator is not used.
CLEANING:
− When cleaning the refrigerator the electric plug must be removed from the power supply.
− Use water and a non-abrasive detergent.
− Clean with a soft cloth soaked in this solution and remove moisture with a dry cloth.
− Remember to clear the defrost drain situated at the back just above the glass cover.

REPLACING THE LIGHT BULB

Should the light fail, switch off at the socket outlet and pull out the mains plug. Then ensure
the bulb is screwed securely in the bulb holder. Replace the plug and switch on. If the light still
fails, obtain a replacement E14 screw-cap type 15 Walt (Max) bulb from your local electrical
sore and then fit it. Carefully dispose of the burnt-out light bulb immediately.
WORKING DEFECTS AND FAILURES
Symptom: Appliance will not work at all.
Cause:
The power supply plug is not inserted in the wall socket or the plug and the outlet is loose.
Due to some anomaly in the household electric supply circuit, no power is reaching the
refrigerator supply socket. This can be checked by plugging in a light or any other electric
appliance into the suspect socket.
The voltage is too low.
-19-