Trouble Shooting And Maintenance - Jocel JF-250LI Manual De Funcionamento

growth, leave the door open slightly: blocking it open if necessary or have the door removed.

TROUBLE SHOOTING AND MAINTENANCE

Trouble Shooting
Power cut
If the internal temperature of the Fridge/Freezer compartment is -18℃ or less when the power
returns, your food is safe. The food in your Fridge/Freezer will remain frozen for approx 16
hours with the door closed. Do not open the Fridge/Freezer door more than necessary.
The Fridge/Freezer is exceptionally cold
You may have accidentally adjusted the thermostat control dial to a higher position.
The Fridge/Freezer is exceptionally warm
The compressor may not be working. Turn the thermostat control dial to the maximum setting
and wait a few minutes. If there is no humming noise, it is not working. Contact the local store
where your purchase was made.
The Fridge/Freezer is not working
Check it is plugged in and switched on. Check that the fuse in the plug has not blown. Plug
In another appliance, such as a lamp, to see if the socket is working. The Fridge/Freezer
should be placed in a well ventilated room with an ambient temperature of between 16℃and
38℃. Leave the Fridge/Freezer for 30 minutes.
Condensation appears on the outside of the Fridge/Freezer
This may be due to a change in the room temperature. Wipe off any residue of moisture. If the
problem continues contact the local store where your purchase was made.
GURGLING, WHOOSHING
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It
has become more pronounced since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your Fridge/Freezer.
HUMMING, PURRING OR PULSATING
This is the compressor motor working, as it pumps the refrigerant around the system.
Changing the internal light
1. Before carrying out the bulb replacement always press and turn the thermostat control to
dial to position "OFF", then disconnecting the mains supply.
2. Hold and lift up the light bulb cover.
3. Remove the old bulb by unscrewing it in an anti-clockwise direction.
4. Replace with a new bulb by screwing it in a clockwise direction marking sure that it is
secure in the bulb holder.
Refit the light cover and re-connect your Fridge/Freezer to the mains supply and switch on.
39