Install The Handles - Kohler K-T194 Guia De Instalacion

Escutcheon
Cap
Plumbers
Valve Stem
Putty
Setscrew

2. Install the Handles

Securely hand tighten the cap onto the valve body.
Apply plumbers putty or other sealant to the back of the
escutcheon according to the putty manufacturer's instructions.
Carefully slide the escutcheon over the cap and press it firmly
against the wall.
Remove any excess putty or sealant.
Loosen the handle setscrew. Press the handle assembly onto the
valve stem so the handle points upward.
Tighten the handle setscrew.
3. Adjust the Water Temperature
NOTE: Prior to adjustment, make sure the handle is in the
maximum hot position.
Remove the handle, cap and escutcheon. Turn the water to the
maximum temperature by pushing the valve stem down and
turning counterclockwise.
Mark the current position of the temperature stop tab (top edge)
on the mounting nut with a marker or pencil. Lift both the
indexer and disc just enough to clear the splines and allow
rotation.
NOTE: Each spline notch represents an average 9.5° F (5.3° C)
temperature change.
1016743-2-B
Mounting
Nut
Handle
Assembly
Splines
Indexer
Cap with
Escutcheon
4
Stop Tab
Valve Stem
Disc
Kohler Co.