New Construction Assembly Instructions; Before Installation - Utilitech 7105-04-L Manual Del Usuario

NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS

NEW CONSTRUCTION – ATTACHING TO THE JOIST
BEFORE INSTALLATION – Turn off power source. Review all
safety precautions.
1. Place the fan housing (A) next to a ceiling joist or wall stud
(1.1). The fan housing (A) should be level and perpendicular
to the joist or wall stud (1.1). Allow for thickness of ceiling
board (1.2) used in your application. DO NOT flush mount to
joist or wall stud (1.1). Bottom of fan housing (A) should be
flush with the ceiling board (1.2).
2. Mount the fan housing (A) to joist using the long wood
screws (AA) on both sides.
Hardware Used
AA
Long wood screw
3. Remove wiring box cover (3.1). Pull the house wires through
the wire box cover hole. Using a quick connector, secure
120 V AC house wiring from the wall switch to the fan as
shown in the wiring diagram on page 5. 14 AWG is the
smallest conductor that should be used for branch-circuit
wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (3.1).
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult
an electrical contractor to determine safely.
4. Install a circular 4 in. duct (4.1) (not included) and secure
it with duct tape or clamps (neither included).
Finish ceiling work. Ceiling hole should be aligned with edge
of fan housing (A).
4
1.1
1.2
2
x 4
Joist
Ceiling board
3
House
wires
4
A
6
A
AA
A
Quick
connector
Product
wires
1.2
3.1
4.1