Internal Safety System - Grammer MAXIMO XT EVOLUTION DYNAMIC Manual Del Usuario

Internal safety system

36
If height or weight adjustment fails, the internal
B
protection system should be checked first.
A
The fuse is located in the upper rear at the
seat suspension underneath the cover (A).
B
To replace the fuse, the cover (A) must be
removed. Pull out bellows pins (B) and
Si
remove the cover (A).
Pull out the defective fuse and replace it by a
new one.
Si 15 A: compressor, level control (height

wire has melted; a blown fuse must always be
replaced by a new one of the same colour
and with the same Ampere value.
adjustment, weight adjustment)
You can identify a blown fuse when its
ATTENTION! Damage!
Do not bridge blown fuses and do
not replace it by a fuse of different
colour or with a different Ampere
value. Otherwise, the driver's seat
might catch fire caused by
overloaded electric lines.
GB