Teamtex mig PLUTO Manual Del Usuario página 6

EN
Many thanks for opting for our child car seat PLUTO. If you require assistance with this product,
please contact our customer service.
WARNING
•
Please read through these instructions carefully before use and keep them for subsequent
reference in order to guarantee the safety of your child. Non-compliance with the instructions
in this manual can result in serious injuries to your child.
•
NOTE – This is an extended i-Size child restraint system with a seat booster for the extended
i-Size child restraint system. Pursuant to Regulation No. 129, it is approved for use in i-Size-
compatible vehicle seat positions as specified by the vehicle manufacturers in the instructions
for operating the vehicle. In cases of doubt, please contact the manufacturer of the child
restraint system or the dealer.
•
 T hechildcarseatMigoPLUTOisapprovedforaheightofbetween76and150cm(max.
36kg).
•
The child seat is approved solely for use in the direction of travel.
•
 I MPORTANT-Donotusethechildseatinthedirectionoftraveluntilthechildhasreached
theageof15months
•
The child seat can only be used with its own 5-point belt system for children under a height
of a 105 cm and with a maximum weight of 24 kg.
•
The child seat CANNOT be used with the 5-point belt system for children who are taller than
105 cm and/or weigh more than 24 kg.
•
From a height of 100 cm (up to a maximum of 150 cm), the 5-point belt system can be removed
from the child seat and the child can be strapped in with the 3-point belt of the car.
•
If the PLUTO is used for children who are between 135 cm and 150 cm tall, it may be the case
that the child seat does not fit into all vehicle types because the vehicle roof is positioned low
on the side of the vehicle selected for the installation of the seat.
•
If the child is taller than 150cm, the child has to move to the vehicle seat and be strapped in
with the 3-point belt of the car.
•
The child seat can only be installed with the Isofix fixation & Top-Tether facing forwards.
•
For the Isofix installation: Please be sure to read the manual from the car manufacturer.
•
Do not use any supporting contact points other than those that are described in the instructions
and are marked on the child restraint system.
•
Do not use this child seat at home. It has not been designed for use at home and should
therefore only be used in your car.
•
Do not leave your child unsupervised on the seat at any time.
•
The child seat should be replaced if it was exposed to heavy impact during an accident.
•
For safety reasons, the child seat must also be affixed in the vehicle when your child is not
sitting in the child seat.
•
Always make sure that all fixation points that hold the seat holder to the vehicle are firm and
that all belts that restrain the child are adjusted to the child's body. Please also ensure that
the belts are not twisted.
•
Items of luggage or other objects that could cause injury in the event of a collision must be
properly secured.
•
The rigid items and plastic parts of a child restraint system must be placed and installed so
that they cannot get caught by a movable seat or a vehicle door during everyday use.
- 10 -
•
Please do not expose the child seat to any direct sunlight. In direct, intense sunlight, the child
seat or parts of it get very hot and this could injure your child.
•
It is important that low-lying belts hold the pelvis firmly in place. Your child should always be
strapped in to avoid the risk of falling.
•
It is dangerous to make changes or additions to the device without the approval from the
authority responsible. Non-compliance with the installation instructions of the manufacturer
of the child restraint system also harbours risks.
•
This child seat has been designed for children between 76 and 150 cm in height and weighing
a maximum of 36 kg. Never overload the child seat by transporting more than one child or
additional loads in it.
•
The child restraint system must not be used without the seat cover.
•
The seat cover must not be replaced by a cover other than that recommended by the manufacturer
as the seat cover is an important component of the restraint performance.
Correctinstallationinavehicle
Note: When you install the child seat, lock the Isofix connectors of the seat to the Isofix holder
of the vehicle. The locked display window of the Isofix system is shown in green. Hook the
Top-Tether into the place envisaged for this in your car and pull it tight until the display window
on the Top-Tether belt turns green.
An installation only with the 3-point belt of the car is not possible.
X
X
- 11 -
Installation only possible on car seats with Isofix connectors
& Top-Tether hook! For this, check the user manual of
your car if applicable.
EN