Teamtex mig PLUTO Manual Del Usuario página 8

EN
Removalofthebeltsystem
•
Loosen the belt
•
Unlock the belt and shoulder pad frame on the
back.
•
Remove the comfort insert from the seat.
•
Now pull the belt from the belt guide and remove
the shoulder pads and belt buckles. Keep them in
a safe place for further use.
•
Now stow the belt behind the seat cover.
•
Place the belt lock for storage in the hollow provided
for this purpose in the seat area underneath the
seat cover.
UseoftheIsofixsystem
•
Insert the insertion aids provided through the slit
in the cushion between the back rest and seating
area and into the Isofix holders.
•
Ensure that the flat side is pointing downwards.
This is not necessary if the vehicle already has
firmly installed insertion aids.
•
Press the two lateral Isofix connector buttons in order
to extend the Isofix connectors to their full length.
•
Insert the Isofix connectors into the insertion aids
and press until you hear them lock.
•
The display on both sides only turns green when
the connections have been established. Press the
child car seat against the back rest until it is standing
securely.
UseoftheTop-Tether
•
In order to loosen the Top-Tether, press the grey
adjustment button with one hand and pull the side
of the belt anchor to the required length with your
other hand.
•
In order to affix the Top-Tether, hang the anchor to
the fixation point on the car seat and pull it as tight
as possible. The display does not turn green until
the belt is locked.
- 14 -
Removal of the
belt lock
INSTALLATION OF THE CHILD CAR SEAT
Height76-105cm
•
Press the two lateral Isofix connector buttons
1
in order to extend the Isofix connectors to
their full length.
•
Place the child seat on the seat of the vehicle.
•
Insert the Isofix connectors into the insertion
aids and press until they lock.
•
The display on both sides only turns green
when the connections have been estab-
lished. Pull the child car seat to the back rest
until it is standing securely.
•
In order to loosen the Top-Tether, press the
2
grey adjustment button with one hand and
pull the side of the belt anchor to the required
length with your other hand.
•
Fix the anchor to the fixation point on the
back of the car seat.
•
Pull the Top-Tether tight by pulling on the
other side of the belt. Make sure that the
display is green.
•
Unlock the belt buckle of the child car seat
3
and place the belt on the outer side of the seat.
•
Put the child in the child car seat.
•
Adjust the height of the head support so that
the shoulder belt remains free.
•
Close the belt buckle again until a "click" can
be heard.
•
Pull on the front adjustment belt in order to
pull the belt tight. Please ensure that the
straps are not twisted.
•
Adjust the shoulder pads so that they fit
comfortably on the child's chest and shoulders.
- 15 -
A
B
C
EN