Electrical Connections - Lamborghini Caloreclima 310 PM/2-E Manual Para La Instalación Y El Mantenimiento

ELECTRICAL CONNECTIONS

The installation technician should perform connections to the mains, thermostat line (TA-TC-TS-TMF) and safety
light if present.
LEGEND
BRM Motor relay coil
C.CT. Connector seal check
CT Thermal relay contact
C.VE.PG. Connector gas valve-gas pressure
EC Control electrode
F Fuses
FA Anti-disturbance filter
IG Main switch
Ima On/Off switch
LF Operating light
LP Lamp presence flame
LR Blocking-mode light
LR1 Blocking-mode light (if present)
MB Burner motor
Servo control motor terminal board LANDIS SQN 30...
MMS
If operating with TMF, it is necessary to remove the connection jumper between terminals  and 5 of the MR transmis-
sion terminal board. Do not exchange the neutral with the phase wire.
Make proper earth connections. COMPLY WITH GOOD ENGINEERING PRACTICES AND OBSERVE THE REGULATIONS IN
FORCE.
MPE Control box terminal board - LANDIS LFL1.322
MR Transmission terminal board
PA Air pressure switch
PGm Minimum gas pressure switch
PS Release-reset pushbutton
RM Motor relay contacts
RT Thermal relay
TC Boiler thermostat
TS Safety Thermostat
Tmf 2nd flame modulation thermostat (if present)
TR Starting transformer
VP Main valve
VS Safety valve
PM/2 Two-stage operation
Remove the bridge -5
35