Installation Steps; Care And Cleaning - MacNeil WeatherYech Easy-On Instrucciones De Instalación

Installation Steps

Peel back 2" (5 cm) of tape liner from each flange.
3
Press and hold hood shield against underside lip (leading edge)
of hood while peeling off remaining tape liner.
5
Apply pressure to both flanges to ensure proper adhesion
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
© 2012 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
Free ends
of tape.
Center hood shield on hood. Ensure free ends of tape liner are
4
Remove remaining tape liner by pulling on the free ends.
6
Adjust bumper stops as needed to ensure hood shield
clears grille and headlights. Close hood, Install (2)
bump ons at pre-cleaned areas of hood surface.
8
Page 2 of 2
accessible.
Free ends