Installation Steps; Care And Cleaning - MacNeil WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Set the hood shield in place, sliding outer tabs UNDER the hood
3
Insert (2) fasteners through the holes in the seal and
hood shield and into the holes in hood.
hood seal
5

Care and Cleaning

•
Wash only with mild soap & dry with a clean cloth.
NOTE: Actual application may vary slightly from illustrations.
seals.
hood shield
A U T O M O T I V E
P R O D U C T S L I M I T E D
2435 WISCONSIN STREET
DOWNERS GROVE, IL 60515
PHONE (630) 769-1500 FAX (630) 769-0300
(800) 441-MATS (6287)
INTERNET ADDRESS: http://www.macneilauto.com
Using a phillips screwdriver install (2) screws with (2)
4
Install bump ons at pre-cleaned locations on the
6
Page 2 of 2
washers through the hood inserts.
square hole
hood
hood insert
hood shield
grommet
screw
DO NOT OVER TIGHTEN
painted hood/fender surface.