Installation Steps - MacNeil WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

3
5
Ensure that center flanges wrap UNDER the top opening in the grill, and that tape tabs are accessible.
6
Remove remaining tape liner by pulling on tape tabs.
7
NOTE: Actual application may vary slightly from illustrations.
Raise hood.
Align hood shield with hood edge.
hood shield center flange
UNDER top opening of grill
Peel back 2" (5 cm) of tape liner from each flange.
4
Install (1) screw in each side flange. Do not over-
8
Page 2 of 3
Tape tabs
hood shield
center flange
UNDER top
opening of grill
CROSS SECTION
tighten.