Charging Procedure - GreenWorks CAM803 Manual Del Operador

OPERATION

CHARGING PROCEDURE

NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use to
ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory
and may be charged at any time.
Low Voltage Charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go
into recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of the
battery. Once it is fully charged, the next charge will return to standard charging.
A fully discharged battery pack will require approximately 60 minutes (2Ah) to fully charge from a
discharged state.
– Plug the charger (1) into an AC power outlet.
– Insert the battery pack (2) into the charger (1).
This is a diagnostic charger. The charger LED Lights (3) will illuminate in specific order to
communicate the current battery status. They are as follows:
2
False defect note:
When the battery is inserted into the charger, and the status LED blinks RED, remove the battery
from the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is
properly charging. If the status LED is still blinking RED, remove the battery and unplug the charger
for 1 minute. After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks
GREEN, then the battery is properly charging. If the status LED is still blinking RED, the battery is
defective and needs to be replaced.
1
LED STATUS
Blinking Green
Solid Green
3
Solid Red
Blinking Red
Charging Fully
Charged
8
Over Charging
Temperature
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
Fault