Important Safety Instructions; Electrical Safety; General Safety - CountyLine CLTS5 1/2 HP Manual Del Usuario

Safety

Important Safety Instructions

SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump .
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
WARNING
Hazardous voltage .
Can shock, burn, or cause
death.
Ground pump before
connecting to power
supply. Disconnect power
before working on pump,
motor or tank.

Electrical Safety

or kill. Disconnect power to pump before working on
pump or motor. Disconnect pump from power before
servicing or handling pump. If in doubt, consult a
qualified electrician.

General Safety

motor. Motors are designed to operate at high
temperatures. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down
before handling.
Do not allow pump or any system component to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
if used as a booster pump unless relief valve capable of
passing full pump flow at 125 psi is installed.
Wire motor for correct
voltage. See "Electrical"
section of this manual
and motor nameplate.
Ground motor before
connecting to power
supply.
Meet National Electrical
Code, Canadian
Electrical Code, and
local codes for all
wiring.
Follow wiring
instructions in this
manual when
connecting motor to
power lines.
Risk of electric shock . Can shock, burn
Risk of burns . Do not touch an operating
Risk of explosion . Pump body may explode
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.
2