Output Settings - Tripp-Lite SmartOnline Single-Phase 5kVA El Manual Del Propietario

Operation
(continued)

Output Settings

Note: Any Output Setting changes require a UPS power cycle.
used to set the UPS' output voltage rating. From the SETUP MENU screen, scroll DOWN
Output Voltage:
OUTPUT SETTING screen. Press ON to reach an OUTPUT VOLTAGE screen and ON again. You can now scroll DOWN
between 5 voltage values: 200/208/220/230/240V. Press ON to save your desired voltage. DEFAULT is set to 208V.
used to set the Frequency Converter Mode. From the SETUP MENU screen, scroll DOWN
Frequency Converter:
the OUTPUT SETTING screen. Press ENTER for the OUTPUT VOLTAGE screen and DOWN
Here, press ON. Now you can scroll DOWN
DISABLE, the UPS will automatically detect input frequency and select 50 or 60 Hz accordingly. The DEFAULT selection is DISABLE.
201102161 933070.indb 22
OUTPUT SETTING
ENT DOWN UP ENT
To ENTER

i h
or UP between DISABLE, 50 and 60 Hz. Press ON to save your selection. When on
OUTPUT SETTING
ENT DOWN UP ENT
To ENTER

FREQ. CONVERTER
ENT
OUTPUT VOLTAGE
DOWN UP ENT
ENT
ENT
ENT
ENT
i
OUTPUT VOLTAGE
DOWN UP

DOWN UP
ENT

ENT
ENT
22
i
until you reach the
i
or UP
*230V*
DOWN UP

220V
DOWN UP

208V
DOWN UP

200V
DOWN UP

240V
DOWN UP
i
until you reach
to access the FREQ CONVERTER screen.
*DISABLE*
DOWN UP

50Hz
DOWN UP

60Hz
DOWN UP
h
3/29/2011 4:34:19 PM