2�5 Information About Electromagnetic Compatibility (Emc); 2�6 Authorised Individuals; 2�7 Liability Exclusion; Product Description - Renfert Dynamix®speed 2 Manual De Instrucciones

► The equipment may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► Always unplug the device from the wall outlet before beginning any work on the unit's electrical
en
components.
► Note any hazard or warning information provided by the material manufacturer.
► Do not operate in an explosion-prone area.
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with.
For Germany these are MPBetreibV in relation with DIN EN 62353 (VDE0751).
► Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this
product. If other spare parts or accessories are used, this could have a detrimental effect on the
safety of the device, increase the risk of serious injury and lead to damage to the environment or
the device itself.
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
2.5 Information about electromagnetic compatibility (EMC)
"Information about electromagnetic compatibility (EMC) can be found in a separate section at the end of
these instructions�"
2.6 Authorised Individuals
This product may not be used by minors under the age of 14�
Only properly trained individuals may operate and service the unit�
Any repairs not specifically described in these operating instructions may only be performed by a qualified
electrician or authorized dealers�
2.7 Liability Exclusion
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions;
► The product is altered in any way other than those alterations described in the operating instruc-
tions;
► The product is repaired by other than an authorised facility or if any but Renfert OEM parts are
employed;
► The product continues to be employed, despite obvious safety faults or damage;
► The product is subjected to mechanical impacts or is dropped.
► We do not accept any liability for damage caused by mixing tips, foil bags or cartridges splitting.
3

Product Description

3.1 General Description
The Dynamix ® speed 2 unit for mixing impression materials facilitates extrusion and mixing of 2-compo-
nent dental impression materials�
5:1 cartridges or foil bags in cartridge holders from different manufacturers can be used in the unit.
Impression materials marked with the symbols
vant mixing programme in the Dynamix ® speed 2�
The mixing programs control the feed rate of the pressure discs and the rotational speed of the hexagonal
head�
Only mixing nozzels should be used which are designated to the impression material by the manufacturer�
or can be extruded in double the speed with the rele-
- 4 -