Cleaning / Maintenance; Cleaning & Maintenance; 6�1 Cleaning The Interior; 6�2 Pressure Disc Replacement - Renfert Dynamix®speed 2 Manual De Instrucciones

6

Cleaning / Maintenance

The device does not contain any parts that require maintenance.
Opening the device other than described in the instructions is not permitted!
Never use cleansers containing solvents.
Never use superheated steam for cleaning!
To clean the unit, merely wipe it down with a moist cloth�
6.1 Cleaning the Interior
• Cartridge bed (14, Fig� 1):
With the pressure discs (9, Fig� 1) retracted, the cartridge bed is easily accessible for cleaning�
• Pressure discs (9, Fig� 1) and spindle covers (10, Fig� 1):
In order to remove deposits and residues from the pressure plates or the spindle cover, it is possible to
move the pressure plates into a suitable position whilst there is no cartridge in place and the device lid
is closed�
NEVER clean the spindles (11, Fig. 1) themselves. The grease applied to spindles is necessary for
the unit's proper function.
Tip:
Remnants of impression material are most easily removed with a dry cloth or paper towel.
In addition to wiping with a moist cloth, the following cleaning agents are approved:
• Incidur Spray (Ecolab)
• Incides N wipes (Ecolab)
Ensure adequate ventilation after using these agents to prevent an explosion-prone area�
6.2 Pressure Disc Replacement
The pressure discs (9, Fig� 1) are subject to wear as a result of their rubbing against the inner cartridge
wall (20, Fig� 1)� Highly abraded pressure plates can damage the foil bag within the cartridge (20, Fig� 1)�
Furthermore, a wrongly placed cartridge can cause the pressure plate to break� Replacement pressure
discs are therefore available as spare part� The spare parts are supplied with the necessary tool and
installation instructions�
6.3 Unit Cover Replacement
The unit cover (8, Fig� 1) is available as spare part�
The spare parts are supplied with the necessary tool and installation instructions�
6.4 Fuse Replacement
Before replacing the fuse, disconnect the unit from the mains power supply by unplugging the
power cord from the wall outlet.
Only replace fuses with new ones that have the same rating as those being replaced� Refer to the
„Technical Specifications" section.
Never use fuses with a higher rating.
⇒ Unplug the unit�
⇒ Pull the fuse holder (17) out�
⇒ Remove the defective fuse and insert a new one�
⇒ Push the fuse holder back in, making sure it is completely seated�
6.5 Spare Parts
You can find components subject to wear and the spare parts on
the spare part list in the internet at www.renfert.com/p918�
Enter the following item number: 25 6200 0000�
The components excluded from the warranty (such as consum-
ables or parts subject to wear and tear) are marked on the spare
part list� Serial number and date of manufacturing are shown on
the type plate of the unit�
- 9 -
17 Fig. 10
en