Replacing Fuses; Antenna Connection - Kenwood TM-281A Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

R
F
EPLACING
USES
If the fuse blows, determine the cause, then correct the
problem. After the problem is resolved, replace the fuse.
If newly installed fuses continue to blow, disconnect
the power cable and contact your authorized KENWOOD
dealer or an authorized KENWOOD service center for
assistance.
Fuse Location
T
a r
n
c s
e
v i
r e
S
u
p
p
e i l
d
A
c c
e
s s
o
y r
D
C
P
o
w
r e
C
a
b
e l
Only use fuses of the specified type and rating; otherwise the
transceiver could be damaged.
Note: If you use the transceiver for a long period when the vehicle
battery is not fully charged, or when the engine is OFF, the battery
may become discharged, and will not have sufficient reserves to start
the vehicle. Avoid using the transceiver under these conditions.
Fuse Current Rating
1
5
A
2
0
A

ANTENNA CONNECTION

Before operating, install an efficient, well-tuned antenna.
The success of your installation will depend largely on
the type of antenna and its correct installation. The
transceiver can give excellent results if the antenna
system and its installation are given careful attention.
Use a 50 Ω impedance antenna and low-loss coaxial feed
line that has a characteristic impedance of 50 Ω, to match
the transceiver input impedance. Coupling the antenna
to the transceiver via feed lines having an impedance
other than 50 Ω reduces the efficiency of the antenna
system and can cause interference to nearby broadcast
television receivers, radio receivers, and other electronic
equipment.
Note: E market models use an N-type antenna connector while
other models use an M-type (SO-239) connector.
Transmitting without first connecting an antenna or other
matched load may damage the transceiver. Always connect the
antenna to the transceiver before transmitting.
All fixed stations should be equipped with a lightning arrester to
reduce the risk of fire, electric shock, and transceiver damage.
Antenna connector
To antenna
Feed line connector
1
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tm-281e

Tabla de contenido