Adjusting The Pause Duration; Dtmf Lock - Kenwood TM-281A Manual De Instrucciones

A P D
DJUSTING THE AUSE URATION
You can change the pause duration (a space digit) stored
in Memory Channels. The default setting is
500 milliseconds.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 31 (PA).
2 Press [MENU] and turn the Tuning control to select
100, 250, 500 (default), 750, 1000, 1500, or 2000 ms.
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.

DTMF LOCK

You sometimes may want to disable the keypad to avoid
accidental DTMF transmission. In this case, turn the
DTMF Lock function ON.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 32 (DT.L).
2 Press [MENU] and turn the Tuning control to select
"ON" or "OFF" (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
When this function is activated, you cannot send
DTMF tones using the Mic keypad. DTMF memory
transmission is also inhibited.
10
53