Mobile Installation - Kenwood TM-281A Manual De Instrucciones

MOBILE INSTALLATION

1
To install the transceiver, select a safe, convenient
location inside your vehicle that minimizes danger to your
passengers and yourself while the vehicle is in motion.
Consider installing the unit at an appropriate position so
that knees or legs will not strike it during sudden braking
of your vehicle. Try to pick a well ventilated location that
is shielded from direct sunlight.
1 Install the mounting bracket in the vehicle using the
supplied self-tapping screws (4), flat washers (4), and
spring washers (4).
• The bracket must be installed so that the 3 screw hole
positions on the side of the mounting bracket are towards
the rear of the bracket.
2
PREPARATION
Self-tapping screw
(5 mm x 16 mm)
Spring washer
Flat washer
2 Position the transceiver, then insert and tighten
the supplied hexagon SEMS screws (4) and flat
washers (4).
• Double check that all hardware is tightened to prevent
vehicle vibration from loosening the bracket or
transceiver.
• Determine the appropriate angle of the transceiver, using
the 3 screw hole positions on the side of the mounting
bracket.
SEMS
screw