[841] Motion Cameras; [901]-[905] Deleting Wireless Devices; [921]-[925] Replacing Wireless Devices; [990][001 - 005] Show All Devices - Johnson Controls Tyco HSM2HOST Manual Del Usuario

[804][841] Motion cameras

To program motion cameras, complete the following steps:
1.
Enter Installer Programming section [804][841].
2.
Select one of the following options by scrolling or entering the hotkey:
[001] VisualVerification
[002] ViewTime Window 01 Alarm + 5 Minutes
[003] ViewOther Alarms

[804][901]-[905] Deleting wireless devices

To delete wireless devices, complete the following steps:
1.
Enter Installer Programming section [804] then select one of the following sub-sections:
[901] – Delete wireless zone devices
[902] – Delete wireless key
[904] – Delete repeaters
[905] – Delete keypads
2.
Select a device to delete using the scroll keys or go directly to a specific device by entering a
hotkey.
3.
Press [*] to delete or [#] to exit.

[804][921]-[925] Replacing wireless devices

To replace a wireless device, complete the following steps:
1.
Enter Installer Programming section [804] then select one of the following sub-sections:
[921] – Replace wireless zone devices
[922] – Replace wireless key
[924] – Replace repeaters
[925] – Replace keypads
2.
Press [*] to select a sub-section. The first available device is displayed.
3.
Select a device to replace using the scroll keys or go to a specific device by entering a hotkey.
4.
Press [*]. When prompted, activate the device (full enrollment) or enter the device ID (pre-
enrollment). A message is displayed confirming enrollment.
[804][990][001 – 005] Show all devices
Use this section to review wireless devices enrolled on the system and to view serial numbers associated
with each device.
To review wireless device information, complete the following steps:
1.
Enter Installer Programming section [804][990] then select one of the following sub-sections:
[001] –Allzones
l
[002] –Repeaters
l
[004] –Wirelesskeys
l
[005] –keypads
l
2.
Press [*] to select a wireless device type. The first available device is displayed.
3.
Use the scroll keys to view the enrolled devices.
Note: This option is not fully supported by LED and ICON keypads.
On: Alarms trigger image capture from PIR Cameras
Off: Alarms do not trigger image capture from PIR Cameras
02 Alarm + 15 minutes
03 Alarm + 1 Hour
01 Fire key enabled/disabled
02 Duress enabled/disabled
03 Medical key enabled/disabled
04 Panic key enabled/disabled
- 12 -