Enrolling The Hsm2Host; Enrollingwirelessdevices; Testing The Wireless Device Placement - Johnson Controls Tyco HSM2HOST Manual Del Usuario

Enrolling The HSM2HOST

The enrollment of a HSM2HOST to an alarm panel is dependent on the system configuration.
Enrolling the HSM2HOST without a hardwired keypad
To enroll the HSM2HOST without a hardwired keypad, complete the following steps:
1.
Turn on the wireless keypad by connecting the power source.
2.
Simultaneously press [*] and [1] on the keypad.
Note:
The system can take up to 30 seconds to complete the enrollment
Enrolling the HSM2HOST with an enrolled hardwired keypad
To enroll the HSM2HOST with an enrolled hardwired keypad, complete the following steps:
1.
On the enrolled keypad, enter Installer Programming section [902][000] (Auto Enroll All
Modules).
2.
When the system prompts you, press [*].
Enrolling the HSM2HOST with only unenrolled hardwired keypads
To enroll the HSM2HOST with only unenrolled hardwired keypad(s), complete the following steps:
1.
Enroll only one hardwired keypad onto the system by pressing any key on the keypad.
2.
Enter Installer Programming section [902][000](Auto Enroll All Modules).
3.
When the system prompts you, press [*] to enroll the HSM2HOST and all other keypads or
modules on the system.
Enrolling wireless devices
To enroll wireless devices, complete the following steps:
1.
Enroll all the wireless devices intended to be used in the system. For more information, see
Wireless device setup and programming
the
with the manual for each wireless device.
2.
Temporarily place the wireless devices in their locations of intended use.
Note:
You must enroll the HSM2HOST to the alarm panel before you can enroll the
wireless devices.

Testing the wireless device placement

To test the wireless device placement, complete the following steps:
1.
Perform a placement test for each wireless device. For more information, see the
ment testing wireless devices
placement test, see the following options:
If all the results pass the placement test, proceed to the
l
the HSM2HOST
If all results do not pass the placement test:, move the HSM2HOST to a different loc-
l
ation, or move the devices that failed the placement test to a different location until all
devices pass the placement test.
section in this manual. Depending on the results of the
section of this manual.
- 8 -
section in this manual, in conjuction
Permanently mounting
Place-