Routine Maintenance; Troubleshooting - Uline H-6489 Manual De Instrucciones

DAILY
1. Filter – Check cartridge filter for clogs or heavy
soiling and replace if necessary. Ensure that correct
filters are being used for the task – see Filters section
of instruction manual.
2. Tank – If vacuuming up wet or damp material,
empty the tank after use, as musty odors may occur
if debris is left inside.
3. Extension Cord and Plug – Check extension cord
and plug for any cuts or damage. If damaged,
replace motor housing unit.
4. Motor – If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately by the Uline service team.
ISSUE
Parts/accessories missing.
Vacuum cleaner will not start.
Dust discharging from exhaust.
Loss of suction.
Static shock.
PAGE 7 OF 21

ROUTINE MAINTENANCE

WEEKLY
1.
2. Hose – Inspect hose for any damage and replace if
MONTHLY
1. Cleaning – Inspect and clean all areas of the

TROUBLESHOOTING

POSSIBLE CAUSE(S)
Packed in tank or box.
No power at receptacle.
Defective switch.
Defective motor.
Filter not installed or installed
improperly.
Filter damaged.
Filter clogged or dust is too fine.
Filter not functional.
Loose hose connection.
Filter clogged.
Full tank.
Hole in hose.
Dry environment.
Relative humidity of air is low.
1-800-295-5510
uline.com
Wands/Tools – Inspect tool attachments for any
damage. Replace if necessary.
necessary.
vacuum, including the inside of the tank.
CORRECTIVE ACTION
Check in tank.
Check for power.
Replace switch.
Replace motor.
Properly install filter.
Replace filter.
Use more efficient filter.
Clean and replace filter.
Tighten hose connection.
Clean or replace filter.
Empty tank.
Replace hose.
Add moisture to air (if practical, use
a console or installed humidifier).
This situation is temporary and does
not affect the use of the vacuum
cleaner.
0521 IH-6489