Routine Maintenance - Uline H-5048 Manual De Instrucciones

WARNING! Unplug the vacuum when performing
any maintenance. Check the condition of all
electrical cords before each use.
UPON RECEIPT
1. Check unit for any defects and missing or broken
parts.
2. Contact Uline with this information, along with any
questions you may have.
DAILY/AFTER EACH USE
1. Check Intercept® Micro Filter. Replace or empty if full.
2. Use only genuine manufacturer's replacement filters
to ensure optimal performance, achieve improved
indoor air quality and to maintain a valid vacuum
warranty.
3. Check micro cloth filter. If dirty, rinse out and air dry
before replacing back into vacuum.
NOTE: All filters must be in place to operate
vacuum. This will optimize airflow and prevent
the motor from laboring.
PERIODICALLY
1. Check harness for fit and comfort.
2. Replace lost or damaged pieces.
ELECTRICAL CORD CARE
1. NEVER stretch the cord tightly between the vacuum
and the outlet. A cord that is stretched or pulled
may not function properly. It can damage the cord
or plug and create a tripping hazard as well.
2. DO NOT tie extension cord and power cord together
in a knot in an effort to keep the connection
together. Doing so will result in damage to both
cords and will not be covered under warranty.
Instead, use the provided cord holder.
3. After vacuuming, unplug the extension cord at both
ends and wind it up loosely.
a. Wind the cord from the female receptacle to the
male plug.
b. Lay the cord out, as straight as possible, on the
floor before winding.
c. DO NOT wind the cord up by wrapping it around
your hand and elbow, as repeated winding in
this manner will result in twisted cord that is hard
to wind and unwind.
PAGE 7 OF 24

ROUTINE MAINTENANCE

4. Use only a manufacturer's replacement extension
5. To reduce the risk of these hazards, be sure the
6. DO NOT use an extension cord with conductors
PROPER STORAGE
1.
MOTOR BRUSHES
Only the Uline Service Team should replace the
carbon motor brushes. Use the following schedule for
replacement:
1. After the first 800 hours of operation.
2. Again after the next 400 hours of operation.
3. Again after the next 200 hours of operation.
cord or one that is properly sized for your
application. Extension cord jacket type should be
SJT or better and rated for outdoor use. Extension
cords in poor condition or too small in wire size can
pose fire and shock hazards.
cord is in good condition and that liquid does not
contact the connection.
smaller than 16 gauge (AWG) in size. To reduce
power loss, use a 14-gauge extension cord if longer
than 50 feet.
When the vacuum is not in use, the vacuum and
extension cord should be stored indoors and in a
dry place.
WARNING! The following information is for
use by qualified service personnel only and
provides guidance for troubleshooting and
maintenance under normal working conditions.
Unplug the vacuum when working on the motor
or any electrical part.
0919 IH-5048