Garage Fan Components; Site Selection & Preparation - Hunter 9020X Guia Del Propietario

Garage Fan Components

Adjustable Leg
Split Sleeve
Adjustable
Leg
Leg Adjust
Lever
Site Selection & preparation
NOTE: Your Garage Fan is intended for mounting at the intersec-
tion of a joist and two braces. See Figure 1. If the location you've
selected does not have such a configuration, then securely install
two pieces of framing material between the joists to form the
intesection.
NOTE: Electrical work and electrical wiring must be done by a
qualified electrician, and must be in compliance with all applica-
ble codes and standards, including fire-rated construction codes
and standards.
1. Select the location on the ceiling from which you wish to hang
your Garage Fan. Ensure the location you've selected has 120V
60 Hz power available within the reach of your Garage Fan's 6'
Power Cord, such as the outlet on most garage door openers. If
no power outlet is available within the reach of your Garage Fan's
Power Cord, then run the proper cabling and an outlet to within
reach of your Garage Fan's Power Cord.
2. Select a location on the ceiling that will not interfere with the
opening and closing of the garage door.
42727-01
Stationary Leg
Split Sleeve
Stationary
Leg
Downrod
Speed Control
Switch

Downrod Cup
Snake Lamp
(Available on
select models)
Continued