Clean Up
10. Disconnect the ground cords from the equipment.
11. Reinstall all equipment covers and close all equipment doors.
12. Disconnect the coil cord from your wrist, and, if necessary, disconnect the
ground cord from the work surface.
13. Properly store the work surface and the other Field Service Grounding Kit
items.
■
Fiber-optic Safety
WARNING:
Eye hazard. Never look directly into a fiber-optic cable, a fiber-optic
connector, or a laser transceiver module. Hazardous conditions might
exist from laser power levels that are capable of causing injury to the
eye.
Be especially careful when using optical instruments with this
equipment. Such instruments might increase the likelihood of eye injury.
The laser transceivers in fiber-optic equipment can pose dangers to personal
safety. Ensure that anyone who works with this StorageTek equipment
understands these dangers and follows safety procedures. Ensure that the
optical ports of every laser transceiver module are terminated with an optical
connector, a dust plug, or a cover.
Each fiber-optic interface in this StorageTek Fibre Channel equipment contains
a laser transceiver that is a Class 1 Laser Product. Each laser transceiver has an
output of less than 70 µW and a wavelength of 850 nm. StorageTek's Class 1
Laser Products comply with EN60825-1(+A-11) and with sections 21 CFR
1040.10 and 1040.11 of the Food and Drug Administration (FDA) regulations.
The following translations are for users in Finland and Sweden who wish to
identify laser safety and classification:
xviii
CLASS 1 LASER
LUOKAN 1 LASERLAITE
KLASSE 1 LASER APPARAT
Sixth Edition
96051