Installing The Replacement Library - StorageTek L80 Manual Del Usuario

Installing the Replacement Library

Figure 1-1. Packing the Library (Continued) (L201_229)
1. Outer Container
2. Container cap
3. Logo label
4. Container locks (Hold so the protruding part is on top. Squeeze the ears and lift the locks to secure
them into the openings.)
5. Accessory container
6. Sleeve
7. Bar code label
8. Top cushion assembly
9. Bag
10. Library
11. Internal bracing items
12. Bottom cushion assembly
13. Front and rear rails (The pallet has wooden bars on each side. Place the rails so they interlock with the
bars.)
14. Rear cushion
15. Pallet
■
Installing the Replacement Library
To install the replacement library, follow the instructions in L80 Tape Library Installation
Manual, 96054.
To configure the library, follow the instructions in L80 Tape Library User's Guide, PN
96021.
Notes: Remember to install the cartridges, external cables, personality module, and drive
1-12
trays into the replacement library.
Always install drives trays by starting at the empty slot nearest the top and
working downward. From a software viewpoint, the drive numbers are assigned
from top (0) to bottom (7). By adding drives in this order, the client software will
correctly reflect the drives previously installed.
When you install the drive trays into the replacement library, slide the drive tray
into the empty slot and turn the drive tray latch to your right. Make sure the tray
is securely latched by pulling back on the tray. It should not move.
Sixth Edition 96051