Armrests; Armrest Adjustment; Backrest Adjustment - Grammer MSG75G Manual De Instrucciones

-
* if fitted ** optional extra
GB
983
+
984
Seat functions and operation
A rm rests * * *
The armrests can be folded back if required
and the height individually adjusted.
To adjust the armrests for height, separate
the round cap (see arrow) from the cover,
loosen the hexagon nut (size 13 mm) behind
it and adjust the armrests to the desired
position (5-steps) and tighten the nut
again ( ). Replace the cap onto the nut.
If the belt roller is fitted, do not install the
armrest in the lowest position as otherwise
the belt roller might not function correctly.
Carry out a
A rm rest adj ustm ent *
The inclination of the armrests can be
modified by turning the adjustment knob.
When turning the knob to the outside (+) the
front part of the armrest will be lifted, when
turning the knob to inside (-) it will be lowered.
B ack rest adj ustm ent
Pull up the locking lever to release the
backrest catch. When releasing the backrest
catch, do not apply load to the backrest by
pressing against it.
By exerting pressure on or off the front or rear
part of the seat pan it can be moved to the
desired position. Release the locking lever to
lock the backrest.
F
It should not be possible to move the
backrest into another position after it has
been locked.
of the belt roller.
23