Operating Instructions - Kobalt K09D-06A Manual De Instrucciones

OPERATING INSTRUCTIONS

1. Trigger Switch
a. To turn the drill ON, press the trigger switch (E).
b. To turn the drill OFF, release the trigger switch.
NOTE: The trigger switch delivers higher speed with
increased trigger pressure and lower speed with
decreased trigger pressure.
2. Lock-on Button
This drill is equipped with a lock-on button (G),
which is convenient for continuous drilling/driving for
extended periods of time.
a. To drill continuously, press and hold the trigger
switch (E) and then press the lock-on button.
Release the trigger switch.
b. To unlock the lock-on button and stop continuous
drilling, press the trigger switch.
3. Direction-of-Rotation Selector
The direction of bit rotation is reversible and is
controlled by a selector located above the trigger
switch (E). With the drill held in the normal operating
position, pointing away from you:
a. Position the direction-of-rotation selector (D) to
the left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
NOTE: To prevent gear damage, always allow the
drill to come to a complete stop before changing the
direction of rotation.
NOTE: The drill will not run unless the direction-of-
rotation selector is fully engaged to the left or right.
1
E
2
E
3
D
Reverse
E
D
8
OPERATING INSTRUCTIONS
4. Auxiliary Handle
This drill is equipped with an auxiliary handle (J). For
ease of operation, you can use the handle with either
the left or right hand. The handle can be rotated 360°.
To adjust the auxiliary handle assembly:
a. Loosen the auxiliary handle quick-clamp by lifting
the auxiliary quick-clamp lever (K) up.
b. With the clamp lever open, turn the handle
counterclockwise to loosen the assembly.
c. Attach the auxiliary handle over the sleeve (A) to
the desired operating position.
d. Press the auxiliary handle quick-clamp lever to
lock the auxiliary handle.
e. Hand-tighten the handle by turning the handle
clockwise.
WARNING
For safety and ease of operation, securely tighten the
auxiliary handle by turning the handle clockwise after
you press the quick-clamp lever down.
5. Live-Wire Indicator Light
The live-wire indicator light (H) is a blue light located
G
in the handle where the power cord enters the
handle. This blue light is always on when the drill is
plugged into a power source.
Forward
E
4
K
A
J
5
9
H