Operating Instructions - Kobalt KRAD 1224B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool,
then slide the battery pack onto the tool, as
shown.
b. Make sure that the battery-release buttons
on the battery pack snap into place and the
battery pack is secured to the tool before
beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull backward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
when the tool is not in use or when carrying the right angle drill/driver at your side.
2. Direction-of-Rotation Selector
(Forward/Center-Lock/Reverse)
The direction of bit rotation is reversible and is
controlled by a selector (D) located near the
variable-speed trigger switch (E). With the right
angle drill/driver held in the normal operating
position, pointing away from you:
a. Position the direction-of-rotation selector (D) to
the left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
c. Setting the selector in the center-lock position
helps reduce the possibility of accidental
starting when the tool is not in use.
NOTICE: To prevent gear damage, always allow the right angle drill/driver to come to a
complete stop before changing the direction of rotation.
NOTICE: The right angle drill/driver will not run unless the direction-of-rotation selector is
engaged fully to the left or right.
1
Battery-release
button
2
Forward
8
Reverse