Spectroline uVision Serie Manual De Instrucciones página 2

Avoid eye and skin exposure to unshielded products.
FOR PROFESSIONAL EXAMINATION USE ONLY.
IMPORTANT SAFETY INSTRUCTIONS (Read all instructions)
Do not operate the uVision™ Series UV-A/White Light LED NDT Inspection Lamp
•
(UV-365ES/UV-365EH) with a damaged cord or if the lamp has been physically
damaged.
• Do not look directly into the light. ALWAYS wear the UV-absorbing protective glasses
provided when operating the lamp. Use in low-light conditions to achieve the best
inspection results. The darker the room, the greater the fluorescent contrast.
• The uVision™ is not approved for use in hazardous atmospheres. Do not attempt to
use it in areas requiring explosion-proof lighting.
• Never use this equipment in any manner not specified in these instructions because
your protection may be impaired.
• NEVER aim the lamp in the direction of another human being. It is meant for
professional fluorescent inspections ONLY!
• DO NOT attempt to modify the lens assembly or light output. Doing so may alter the
performance and intensity of the uVision™.
OPERATION
• The uVision™ series UV-A inspection lamps are equipped with an 8-foot (2.4 m) heavy-
duty cord ending in an AC plug with a protective rubber boot.
• The lamp is shipped with the correct cord installed for the country of destination.
• Connect the plug to a power source that complies with the electrical requirements
specified on the label.
• The lamp has a three-position rocker power switch (II – UV; O – off; I – white light) on
the handle.
• WARNING: Be sure to use genuine uVision™ replacement parts. Using another
manufacturer's replacement parts could affect product performance and will void the
warranty.
WARNING:
UV light emitted from this product.
Rocker Switch
2