Milwaukee WCE 65 Manual Original página 5

Switching on Quick break operation
and off
Switching on:
Press switch lock and then on-off switch.
Switching off:
Release on-off switch.
Constant operation
Switching on:
Depress the switch lock and then the On/Off
switch. Release the On/Off switch, then re-
lease the switch lock.
Switching off:
Depress and release the On/Off switch.
Only use the machine with a suitable dust-remover!
Dust extraction
Insert the suction hose connector into the
ENGLISH 4
adapter until it sits firmly. Connect the other
end of the suction hose to a vacuum cleaner
which is suited for dust extraction.
Due to the high current at make the wall
chaser cannot be connected directly to the
socket at the vacuum cleaner. Do not switch
on the vacuum cleaner and the wall chaser
simultaneously!
Exchanging the Always disconnect the plug from the socket before carrying out any work on the
diamond cutting machine.
discs
Disassembly 1. Put the machine on its side.
2. Loosen the screws and open and remove the protective cover. Move the protective
cover outwards (height gauge).
8 ENGLISH
1
2
WCE 65
ENGLISH
Spanntec-nut
Hexagon nut
3. Lock the work spindle by depressing the spindle lock. Loosen the round nut of the
upper cutting disc with aid of a pin-type face spanner.
4. Loosen the hexagon nut with aid of the fork wrench SW 17. Remove the nut and the
washer.
5. Remove the round nut and the front cutting disc.
Tension flange
6. Remove the Spanntec-spindle with the Spanntec-nut and the lower cutting disc.
Assembly 1. Insert the tension flange.
2. Assemble the machine in reverse order.
Arrow on diamond cutting discs must agree with arrow on protective hood cover-
direction of rotation.
7
Round nut with drilled
holes in one face
Spanntec-spindle
ENGLISH
WCE 65
9