Kohler K-702205 Guia De Instalacion página 11

Install the Door Panels (cont.)
Move the outside panel to the side opposite the showerhead.
Confirm Proper Operation
Carefully remove the caution tape and protective strip from both door panels.
Roll each door panel back and forth along the track to make sure they operate smoothly.
If both door panels operate smoothly, perform the "Confirm Panel Alignment" instructions later in
this section.
If one of the door panels does not operate smoothly, remove it and make sure there is no debris or
rough areas on the rails inside the top track.
If no debris or rough areas are found, adjustment is required.
If adjustment is required, determine if the door panel should be raised or lowered.
Remove the door panel from the top track.
Adjust the rollers by loosening the roller screw and moving the roller to a different hole.
To adjust the door panel higher, move the rollers lower.
To adjust the door panel lower, move the rollers higher.
Reinstall the door panel.
Repeat if necessary.
Confirm Panel Alignment
NOTE: The edge of each door panel must touch the bumpers before coming in contact with the wall
jambs. If the door panels do not touch the bumpers first, the wall is not plumb and the door panel needs
to be adjusted.
Check to be certain that the door panel is plumb with the wall and the door panels come in contact
with the bumpers, not the wall jamb.
If adjustment is required, determine whether the top or bottom of the door panel is closer to the
wall.
Remove the door panel from the top track and adjust the roller on the side of the door panel closest
to the wall.
Adjust the rollers by loosening the roller screw and moving the roller to a different hole.
If the bottom of the door panel on the side being adjusted is farther away from the wall than the
top of the panel, raise the roller.
If the top of the panel is farther away from the wall than the bottom of the panel, lower the roller.
Reinstall the door panel.
Repeat if necessary.
Kohler Co. 11 1054857-2-C