Master Compressor Setting (CH3 controls): CH3 meter Indicates Master Compressor Type.
Press CH3 Filter Mode
Option 1: No Compression
Option 2: Soft Knee Compressor/Limiter
Option 3: Soft Knee 6:1 Opto-Compress
Option 4: Hard Knee Look-Ahead Peak Limiter
Factory Default: Hard Knee Look-Ahead Peak Limiter
Recommended Usage: To maximize dynamic range and control the maximum output level precisely, select
Option 4. Option 3 is most recommended when the Channel Compressor is not enabled.
Filter Mode Activation (CH4 Filter control): CH4 filter button will indicate function activation
Press CH4 Filter Mode
lenses will light up when filter mode is enabled.
Factory Default: Filter Mode Enabled
Recommended Usage:
capability, however, filter mode can be a very useful tool. With the channel compressors enabled, the output
level will not increase significantly even when the filter resonance is maximized. However, for those who are
wary or unfamiliar with filters the option to disable it is available.
Tube Warmth Setting (CH4 Cue controls): CH4 Cue button will indicate function activation
This will create a slightly fuller and warmer sound through analog modeling technology.
Press CH4
to enable and disable. If Cue LED is on in the function is active.
Factory Default: Enabled
Recommended Usage: Recommended for a warm full sound. Although it adds harmonic distortion, it is
pleasant and subtle to the ear.
Mic in Booth Output Setting (FX Cue): FX Cue button will activate insertion mic into booth
Press FX
to enable and disable. When enabled, the microphone will be included in the Booth output.
Factory Default: Disabled
Recommended Usage: By removing the microphone from the booth output the DJ can make announcements
and still monitor the music without worrying about feedback.
Master Level Lock Control (Master Volume/Mic 1): Mic 1 ON to activate
Press
and the current position of the MASTER LEVEL control will be set as the maximum level. When
the mixer is in operation the user will not be able to increase the output volume beyond this level. Moving the
knob past the set point will have no effect.
Factory Default: Disabled
Recommended Usage: For situations where the mixer is being permanently installed, this feature is highly
recommended for ensuring that the sound system can achieve maximum sound quality and loudness without
clipping, or worse, damaging equipment.
to toggle the compressor settings.
to enable and disable filter mode capability.
Filter mode is not for everyone. Some club installers may prefer to disable filter mode
in the CH1-4 info