Warn 74500 Manual Del Usuario página 12

Programming LED
Programming button
Warn Industries, Inc.
10
PROGRAMMING THE RECEIVER
The hand held remote (transmitter) is programmed from the
factory to communicate with your specific receiver. Under
normal circumstances programming will not be necessary.
However, any replacement remote must be programmed to
communicate with your receiver. Use the following
procedure:
1. Insure the system is properly installed and connected.
2. Turn the ATV ignition key to ON.
3. Activate the system by pressing and holding both buttons
until the GREEN LED lights up.
4. Press and hold the receiver programming button for at
least five (5) seconds until the RED LED on the receiver
lights up and stays on.
5. Release the programming button.
6. Press the power IN button on the remote for at least one
(1) second until the RED LED on the receiver turns off.
Programming is now complete.
NOTE: Only one remote can be programmed for each
receiver.
WARRANTY
Please refer to the warranty sheet enclosed with your winch
for details.
REPLACEMENT PART NUMBERS
Ordering information: Parts may be obtained through your
local dealer or distributor.
Part Number Description
PN 74502 Receiver Module
PN 74524 Holster
PN 74525 Harness
PN 74604 Hardware Kit
PN 74520 Replacement transmitter (remote)
The above list represents the most commonly requested
replacement parts. A full listing of replacement and service
parts are available. Check with your WARN authorized dealer
or on the web: www.warn.com