Warn 74500 Manual Del Usuario página 6

Warn Industries, Inc.
4
OVERVIEW
The WARN Wireless Control gives you the ability to operate
the winch using a wireless hand held remote. The wireless
control system integrates with the standard handlebar switch
and remote so that the operator may use either the wired or
wireless controls at any time.
To use the wireless system, the operator first activates the
system by pressing and holding both buttons on the wireless
remote for 3 seconds. This transfers control of the winch to
the wireless control system. The GREEN indicator light on
the handheld remote glows when the system is active and
ready to use.
After 2 minutes of idle time, the wireless system de-activates.
SAFETY
When installing your winch and winch control system, read
and follow all mounting and safety instructions. Always use
caution when working with electricity and remember to verify
that no exposed electrical connections exist before
energizing your winch circuit.
SPECIFICATIONS
Part numbers for complete system:
PN 74500 (wireless control upgrade kit)
PN 74600 (kit supplied with new ATV winch)
Transmission range:
15-27 m (50-90 ft.)
Receiver Operating voltage:
8 to 24 VDC
Receiver Fuse type and current rating:
ATC 7.5 amp
Batteries for hand held remote:
two alkaline, 12 volt, type 23
WIRELESS CONTROL
KIT INCLUDES:
Wireless Receiver (1)
Wireless Transmitter (1)
Wiring Harness (1)
Holster Assembly (1)
Hardware Kit (1)