Warn 74500 Manual Del Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
TO PREVENT SERIOUS INJURY
OR DEATH FROM ELECTRICAL
FIRE:
Do not route electrical cables
across sharp edges.
Do not route electrical cables
through or near moving parts.
Do not route electrical cables
through or near any high heat
parts.
Avoid pinch and wear/abrasion
points when installing all electrical
cables.
Use a test light to locate a
switched accessory wire.
STEP 4: CONNECT THE WIRING
Note: Refer to Figure 1.
1. Pull apart the bullet connectors on the BLACK and
GREEN wires identified in Step 3 above. These will be
located near the contactor
2. Connect the BLACK and GREEN wires to the same color
wires on the wire harness as shown on the wiring diagram.
3. Connect the BLACK ground wire with the ring terminator to
the battery as shown.
4. Using a test light, locate a switched accessory wire
attached to the ATV ignition system. The wire should only
have power when the key is in the "ON" position.
5. Splice the RED wire to the key controlled accessory wire
using the provided wire splice.
6. Connect the other end of the wire harness to the receiver
and tighten the mounting bolts on the receiver.
7. Use tie wraps to secure the wire harness
green
black
black
Figure 1: Wiring Installation Diagram
green
black
red
WARN Wireless Control Installation Guide 7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

74600

Tabla de contenido