Error Messages - Klarstein MAISCHFEST Manual Del Usuario

EN
16

ERROR MESSAGES

E1 Open circuit on the hot
conductor
E2 Short circuit on the hot
conductor
E3 Device runs dry
E4 Temperature at sensor
too high
The hot conductor is damaged, has a poor contact,
has fallen off or is disconnected. Contact a
specialist company for repair.
The hot conductor is damaged or has been short-
circuited. Contact a specialist company for repair.
The built-in dry-running protection has reset the unit
due to excessive temperatures. Please check that,
if viscosity of liquid is too high, it must be stirred
regularly especially in area of temperature sensor
to avoid thermostat issues. Press on the reset pin on
the bottom of the boiler. When a sound is heard, the
boiler is ready for operation again
The temperature in the boiler rises by more than
30°C in one minute or too little water in the boiler.
Please check that, if viscosity of liquid is too high,
it must be stirred regularly especially in area of
temperature sensor to avoid thermostat issues and
more water may need to be added. Press on the
reset pin on the bottom of the boiler. When a sound
is heard, the boiler is ready for operation again.