Connect Ductwork - Best IEX170 Manual Del Usuario

CONNECT DUCTWORK

1. Position the hood near the lower part of
the support frame and connect the duct to
the discharge collar.
2. Use 8" round metal duct to connect the
discharge collar on the hood to the
ductwork above.
3. Use duct tape to make all joints secure and
air tight.
MOUNT HOOD TO SUPPORT
FRAME
1. Install the hood to support frame using (6)
mounting screws (3,9x9,5mm). Make sure
that the controls are on the proper side.
2. Make electrical connections (refer to the
section "WIRING").
3. Remove the two temporary retaining
screws from the lower flue and set it in
place on the hood.
DISCHARGE COLLAR
- 10 -
8" DUCT
MOUNTING
SCREWS
(3,9X9,5MM)